I took my starter off completely cleaned it out took forever and put it all...

I took my starter off completely cleaned it out (took forever) and put it all back together and took it outside and hooked jumper cables to my batt. And then to the starter to bench test it IT WORKS! Yaaaaay but I put it back on and pushed the button and all it did was make the same click sounds booooo so I took the hot cable and tried to jump to the post on top of the starter when it was on the bike and it doesn't work? Took it back off hooked the jumpers up and it works again put it back on nothing... Think it's connection?

Kyle Goodrich- just cuz you always know lmao

4 comments
  • Could be going out of phase under load

  • jump the solinoid

  • It wont jump across the silinoid

  • try the solenoid it may be bad